Parts by Request
Red Light Bed Parts
Sun Systems & Service sources parts for red light therapy beds, red light panels and hybrid tanning beds. Most red light beds are sold online by companies that ship a crate and are hard to reach once something fails. We are the technicians who fix them. Tell us the make, the model and what the bed is doing, and Stan Pope, who has worked on light-based beds since 1990, confirms the part and ships it to you, anywhere in the US. Not sure what failed? Start with a video session. Call (248) 545-5577.
Red light bed parts we source
- LED panels and arrays. Replacement panels for sections that are dark, dim or showing dead diodes.
- LED drivers and power supplies. The most common reason one section of a red light bed goes dark. We test the driver before anyone buys a panel.
- Control boards and timers. Main boards, touch controls, session timers and remote timer systems.
- Cooling fans. Red light beds run warm and shut down when cooling fails. Fans, fan controllers and thermal cutoffs.
- Acrylics and covers. Bench and canopy acrylics for cracked, crazed or hazed beds. See acrylics.
- Gas springs and canopy hardware. For lids that drift down or will not stay open. See gas springs.
- Wiring, connectors and electrical. Harnesses, connectors, relays and cords. See electrical.
Hybrid tanning bed parts
A hybrid bed is a tanning bed with red light built in, so it needs parts from both worlds. We source UV tanning lamps and red light lamps, ballasts, starters, LED panels and drivers, timers and fans, and relamp hybrids as a matched set.
Common red light bed problems and the part behind them
- One panel or row is dark: driver or power supply first, then the connector, then the panel.
- Whole bed dead: breaker, cord, main relay or control board. See bed won't turn on.
- Shuts off mid-session: cooling fan or thermal cutoff.
- Trips the breaker: circuit size or a shorted component. See bed keeps tripping the breaker.
- Output seems low: aging panels, dirty acrylic or a failing driver. See red light bed irradiance explained.
Not sure which part?
Book a virtual repair session, show Stan the bed on your phone, and he names the fault and the part. We ship the part and walk you through the install on a follow-up call.
Request a red light bed part
Frequently asked questions
Where can I buy replacement parts for a red light therapy bed?
Sun Systems and Service sources red light bed parts by request: LED panels and arrays, drivers and power supplies, control boards and timers, cooling fans, acrylics and gas springs. Tell us the make, model and part, and we ship it anywhere in the US.
Can a red light bed be repaired instead of replaced?
Usually, yes. Most failures are a single dead LED panel, a failed driver or power supply, a cooling fan, or a control or timer fault. Replacing the part is almost always far cheaper than replacing the bed.
Why is one section of my red light bed dark?
Usually the LED driver or power supply feeding that section, a loose connector, or the panel itself. We test the driver output before replacing a panel, because the driver is the cheaper and more common failure.
Do you carry parts for hybrid tanning beds with red light?
Yes. We source both sides: UV lamps, red light lamps, ballasts, starters, LED panels, drivers, timers, fans and acrylics.
Do you ship red light bed parts nationwide?
Yes, anywhere in the US. If you are not sure which part failed, a video session with Stan confirms it before you buy.