ProSun Tanning Bed Parts by Request

ProSun International is a long-running American manufacturer of commercial tanning equipment. The company traces its start to 1979 and builds lay-down beds, stand-up booths and, more recently, red light and wellness equipment at its factory in Florida. ProSun beds are a fixture in Michigan salons, and because the company has been building for decades, there are older ProSun units in service alongside the current lines. Sun Systems & Service has worked on ProSun equipment for most of our 35 years. We source ProSun tanning bed parts by request, including for older and discontinued models, and we install in Michigan or ship nationwide after a video session.

What ProSun beds are known for

Commercial-grade construction and a wide line. ProSun has built everything from mid-size lay-down beds to high-output beds with facial lamps and tall stand-up booths with high lamp counts. That range means the parts conversation depends heavily on the model: a stand-up booth has different lamps, larger blower fans and a different acrylic arrangement than a lay-down bed, and the higher-output beds use lamp classes and ballasts that smaller beds do not. The electrical requirement is nearly always a dedicated 220 volt circuit sized to the model.

We service and source parts for ProSun beds

Current models and the older generations still running in salons. Relamps are the most frequent request, often on a schedule as part of a salon maintenance plan. Acrylics on heavily used salon beds, gas springs on the lay-downs, fans and thermal parts on the stand-ups, and control boards and timers across the line round it out. For discontinued models we work from the plate, the lamp code and measurements, and we tell you straight if a board cannot be had.

Finding the model and serial plate

On ProSun lay-down beds, look at the end of the base or inside the base near the lamp ends. On stand-up booths, check inside the door frame or low on the rear panel. The plate names the model, serial number, voltage and amperage. have a photo ready of it with your request. If the plate is gone, photos of the bed, the control panel and a lamp end label get us most of the way.

Common ProSun part requests

• Lamps. Full relamps as a matched set, with the code confirmed against the bed's own requirement rather than against the model name.
• Acrylics. Bench and canopy sheets, matched to the model and production year, since dimensions changed across years on many lines.
• Gas springs. Canopy shocks matched by length, force and fitting. Replaced in pairs.
• Ballasts. Magnetic and electronic, matched to the lamp class and voltage.
• Starters. Sized to the lamp wattage, included with every relamp.
• Timers. In-bed timers, remote timers and control boards.
• Fans and cooling parts and electrical parts such as contactors, lamp holders and cords.

Michigan and nationwide

In Michigan we come to the salon or the home, install the part and test the bed at full output. We have served hundreds of Michigan salons since 1990 and we are open 7 days, 9 to 6. Outside Michigan, book a virtual repair session: Stan looks at the bed on your phone, names the part, we ship it, and he walks you through the install on a follow-up call. Buying a used bed of this brand? A video inspection before you pay tells you what it will need.

More parts by request

• Tanning bed lamps and bulbs
• Ballasts
• Starters
• Acrylics
• Gas springs and canopy shocks
• Timers and controllers
• Fans and cooling
• Electrical parts

Request a ProSun part

Send the model, the part and your city. Stan confirms the part against the bed and quotes it, usually the same day.

Name

Phone

Email

City and state

Bed make and model

Part needed

Model plate

Request this ProSun part

A clear photo of the model plate and of the part itself saves a round of questions. Reply to the confirmation email with both.